Panasonic DMC-LS2 - Manual (Page 85)

Others
85
VQT0V10
∫ Card
Do not leave the card where the
temperature is high, where
electromagnetic waves or static
electricity are easily generated or
exposed to direct sunlight.
Do not bend or drop the card.
• The card may be damaged or the recorded
content may be damaged or deleted.
• Put the card in the card case or the
storage bag after use and when storing or
carrying the card.
• Do not allow dirt, dust or water to get into
the terminals on the back of the card and
do not touch the terminals with your
fingers.
∫ Batteries
Be sure to remove the batteries when
you will not be using the camera for a
long period of time.
• If the temperature is too high or low, the
terminals may rust causing a malfunction.
If you drop the batteries accidentally,
check to see if the body of the batteries
and the terminals are damaged.
• Inserting a damaged battery in the
camera will damage the camera.
Bring charged spare batteries when
going out.
• Be aware that the operating time of the
batteries becomes shorter in low
temperature conditions such as at a ski
resort.
Dispose of unusable batteries.
• Batteries have a limited life.
• Do not throw batteries into fire because
they may cause an explosion.
• Unusable batteries should be discarded in
accordance with battery recycling laws.
Call the RBRC hotline on 1-800-822-8837
for information.
Do not allow battery terminals to come
into contact with metal objects (such as
necklaces, hairpins, etc.).
• This can cause short circuiting or heat
generation and you may be badly burned
if you touch the batteries.
Message Display
Confirmation messages or error messages
will be displayed on the screen in some
cases.
The major messages are described below
as examples.
[CURRENT BATTERY TYPE SETTING:
OXYRIDE]/[CURRENT BATTERY TYPE
SETTING: ALKALINE/Ni-MH]
This message is displayed the first time you
insert batteries and when the batteries are
exhausted and you replace them. If the
battery type being used is different from the
one indicated in the message, change the
battery type in [BATTERY TYPE] in the
[SETUP] menu. (P20)
[THIS MEMORY CARD IS PROTECTED]
The Write-Protect switch on the SD
Memory Card is moved to [LOCK]. Move
the switch back to unlock it. (P17, 71)
[NO VALID PICTURE TO PLAY]
Record a picture or insert a card with a
recorded picture and then play it.
[THIS PICTURE IS PROTECTED]
Delete or overwrite the picture after
canceling the protect setting. (P70)
[THIS PICTURE CANNOT BE DELETED]/
[SOME PICTURES CANNOT BE
DELETED]
Pictures not based on the DCF standard
cannot be deleted. If you want to delete
some pictures, format the card after saving
necessary data on a PC etc. (P74)
VQT0V10ENG.book 85 ページ ２００５年１２月２７日 火曜日 午後８時３４分