Pentax IC-360 - Manual (Page 17)

C. Assigning an IP Address with the ARP Command
1) Using ARP in Windows
When the PC’s operating system is Windows 98, 2000, Me, XP, or NT, follow the steps below.
•
Open a DOS window and type the following commands.
Arp -s <VersaCam IP address> <VersaCam MAC address>
Ping <VersaCam IP address>
•
Example
Arp -s 192.168.1.3 00-40-8c-10-00-86
Ping 192.168.1.3
2) Using ARP in Windows 95
When the PC’s operating system is Windows 95, follow these steps.
•
Open a DOS window and type the following commands.
Arp -s <VersaCam IP add.> <VersaCam MAC add.> <my PC IP add.>
Ping <VersaCam IP address>
•
Example
Arp -s 192.168.1.3 00-40-8c-10-00-86 192.168.1.2
Ping 192.168.1.3
3) Verifying Installation
After completing the tasks above successfully, the following messages or similar ones will appear on
the screen:
Request timed out
:
Request timed out
Reply from 200.243.232.178: bytes=32 time=2ms TTL=255
Reply from 200.243.232.178: bytes=32 time=2ms TTL=255
Ping statistics for 200.243.232.178:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milliseconds:
Minimum = 1ms, Maximum = 2ms, Average = 1ms
If you don’t receive the reply by using the 'ping' command, try pressing 'F3' and 'Enter' keys again.
Normally ‘Request timed out’ messages appear 7 times before you receive a proper reply.
VersaCam IC-360 User’s Guide 11