Primera Technology CX1200 - Manual (Page 46)

42 Media Recommendations
6. Fuser Heat tolerance - wrinkling, bubbling, burning, Breaking, Curling
7. Water
Tolerance
8. Scratch Tolerance
9. Cut quality
10. Lamination Quality
Note 1: Test at least 100 feet of continuous material before determining compatibility. Some Plastic stocks
will initially appear to be compatible. However over time, the material absorbs too much heat so that not
enough is left over to fuse the toner to the surface of the material.
Other Warnings
Do NOT print on die-cut label materials or on web widths of less than 8.5” (215mm). Labels should
always be die-cut as a post process on a separate piece of finishing equipment. Printing on die-cut
materials is dangerous. Adhesive bleed can easily ruin the Image Transfer Unit (ITU) and fuser. A
label that pre-dispenses inside the unit can cause physical damage to the printer.
TOC INDEX