Primera Technology CX1200 - Manual (Page 55)

Maintenance and Troubleshooting 51
The printed colors do not match the screen. The colors of the label shown in PTPrint may not
match the original design program, other print programs or the printed output of the CX1200.
There are no ICC profiles available to make colors shown in PTPrint match the printed output or
other programs. The colors shown on screen will have no effect on the printers ability to print
specific CMYK values or Pantone Matched CMYK values.
Default Settings NOT set. This error appears before printing or when the status monitor is
opened. Specific settings will be listed belowthe error message. This means that default settings
were changed via the printer control panel or through the print settings window before printing.
The message is a warning that the settings do not match defaults. If you do not change the settings
back to their original values unexpected errors may occur. Contact tech support if you have trouble
restoring the defaults.
9.7 Replacing the Fuser
1. Pull the tensioner forward until you are able to flip
the housing back out of the way of the printer doors.
2. Open both the upper right and the lower right
access doors.
Warning: The fuser assembly may be hot. Let it cool
before continuing.
3. Pull down the green latches. They slide toward the
center to release the fuser.
4. Pull the fuser out, and set it on a clean, flat surface.
5. Insert a new fuser into the printer.
6. Slide the latches out, and then pull up to refasten them.
7. Close the doors.
Figure 9-2.
!
Figure 9-3.
TOC INDEX