Patton electronic 2996 User Manual
Page 28
Advertising
Preparing the RAS for configuration
28
Model 2960/2996 RAS User Manual
3 • Configuring the RAS for operation
– 8 bits
– No Parity
– 1 Stop bit
– No flow control
3. Set up HyperTerminal™ as follows:
– Open a HyperTerminal session.
– Enter a name for this connection.
– Click on the Connect using: pop-up menu and choose the Direct to ComX option (where X is the number
of the COM port onto which you connected the cable in step 1) (see
).
Figure 13. Hyperterminal properties
– Configure the COM port settings as shown in
.
Advertising
This manual is related to the following products: