Planet Technology VIP-101T - Manual (Page 24)

PLANET VIP-101T CLI configuration
- 18 -
Parameter –plan is used to setup dialstring length. While the number (E.164 number in
phone book) you dialed is 7 digits, this parameter should be configured as 7 or 0.
Syntax Description
-plan dial string length ( number 1 ~ 24 to limit the dialed digits, 0 for unlimited, but
Max. dialed digits is 24. )
Default
0 (not limited, Max. allowed dialed digits count is 24.)
c) –callalive
VIP-101T is able to check if there are network activities during calling process.
Parameter –callalive can enable or disable auto-disconnect operation after 10 seconds
not receiving packets from remote calling party
Syntax Description
-callalive Enable or disable auto-disconnection after 10 seconds not receiving
packets from remote party. 0 for disable and 1 for enable
Default
0
d) –keypad
Parameter –keypad is used to setup DTMF transmission method. You may select DTMF
type in VIP-101T for DTMF receiving and transmitting activities.
Syntax Description
–keypad 0/1/2/3 (0 for inband ,1 for H.245 alphanumeric, 2 for H.245 signal type, 3 for
Q.931 user info, 4 for RFC2833.)
G
Hint
1. If this parameter is set to 0, this will disable length checking in phone book (Max.
dialed digits is 24), and dialing string between 1-24 digits can be set.
2. By default settings, symbol ”#” is used to send out the dial-string. If you don’t wish
to wait the dialed digit interval timeout, you may press “#” key to send out numbers
to desired destinations.