Planet Technology VIP-101T - Manual (Page 28)

PLANET VIP-101T CLI configuration
- 22 -
running mode is Peer-to-Peer mode.
Syntax Description
–mode 0/1 (0 for GateKeeper mode ,1 for Peer-to-Peer mode)
Default
1 (Peer-to-Peer mode)
c) –gk
This parameter is used to configure primary GateKeeper IP address
Syntax Description
–gk IP address or URL of destination Gatekeeper
Default
Null (This command has no default value.)
d) –dfgw
Parameter –dfgw to configure IP address of default H.323 communication gateway, this
option is same as the gateway settings in advanced calling option of Microsoft
NetMeeting.
i) To complete the calls, both calling and called endpoints must be running in
peer-to-peer mode.
ii) If the called party equips FXO interface connected with PBX or PSTN line, to
establish the communications, please add sysconf –2nddial 0 parameter to make
this one-time dialing working.
iii) In this mode, if you like to dial remote PSTN number via default gateway
configuration, VIP-101T will dial to default gateway first, then the remote gateway will
forward this number to PSTN line, and connect the call.
iv) If called party equips with FXS interface, you may directly dial an existing telephone
number on the remote gateway to establish the voice communication.
G
Note
1. In the GK IP field, URL can be inserted as well. Please note:
Domain Name Server must be configured in -ifaddr configuration menu, so that the
URL can be functional here.
2. If GK IP address is set to 255.255.255.255; VIP-101T will be set to run Gatekeeper
Auto-discovery mode. It is required to configure parameters –gkname and –gkdis to
complete the GK Auto-discovery configuration.