Planet Technology VIP-101T - Manual (Page 25)

PLANET VIP-101T CLI configuration
- 19 -
Default
2 (H.245 signal type)
e) –idto
Parameter –idto is used to setup the interval (in second) of two pressed digits, iff there
is no action in this duration, VIP-101T will dial out the pressed numbers.
Syntax Description
-idto Interval between dial string Digits.
Default
5 seconds
f) –eod
Terminal digit selection, once this specified digit is pressed on the keypad, VIP-101T will
send out the dialed digits.
Syntax Description
–eod 0/1/2/3 (0 for no end of dial key , 1 for “OK” button , 2 for “#” button , 3 for
“＊” button )
Default
#
g) -h450
Parameter –h450 can be used to enable or disable the H.450 features supported in
VIP-101T. H.450 service supported: call transfer, call on hold and call forward.
Syntax Description
-h450 Enable or disable H.450 related features.
Default
1 (H.450 service is turned on)
G
Note
It is not suggested to change this parameter without assistance of your VoIP or PBX
system administrator.