Planet Technology XRT-411 - Manual (Page 34)

Broadband Router User Guide
30
5. Select the desired device and port, and then click the "Add" button.
Under Windows 95, if you see the following error message,
either install Internet Explorer 4 or later, or follow the proce-
dure in the "Trouble Shooting - Printing" section of
Appendix A.
6. A pop-up message will inform you if the port has been created successfully, and
then the Windows Add Printer wizard will start.
•
Select the correct Printer Manufacturer and Model, or use the "Have Disk" op-
tion if appropriate.
•
If desired, change the Printer name so it indicates the device used (e.g.
HP2100 on SCA43600)
•
If prompted about Sharing, do NOT enable Sharing.
7. Installation is now complete. You can now print using this printer.
•
Use the Start menu to run this program in future. The default installation is
Start - Programs - Broadband Internet Router - Add Port.
•
There are some options which can be set for the driver. See the following sec-
tion Port Options for details.
Management
•
Print jobs can be managed like any Windows printer. Open the Printers folder
(Start - Settings - Printers) and double-click any printer to see the current print jobs.
•
If the printer attached to the Broadband Router is changed, just run this program
again, and select the correct printer.
•
To delete a port created by this setup program, use the Windows Delete Port
facility:
•
Right-click any printer in the Printers folder, and select Properties.
•
Locate the Delete Port button. This button is on the Details or Ports tab, de-
pending on your version or Windows.
•
If the Broadband Router's LAN IP Address is changed, and you can no longer print,
delete the port (see procedure above) and re-install it.
Port Options
The options for the Print Port Driver are accessed via the Windows Port Settings
button.
Use Start - Settings - Printers to open the Printers folder, then right-click the Printer,
and select Properties. The Port Settings button is on the Details or Port tab, depending
on your version of Windows.
An example screen is shown below: