Planet Technology XRT-411 - Manual (Page 9)

Introduction
5
Rear Panel
Figure 3: Rear Panel
USB Printer Port
If you wish to share a printer, connect it here.
Reset Button This button has two (2) functions:
•
Reboot. When pressed and released, the Broadband
Router will reboot (restart).
•
Clear All Data. This button can also be used to clear ALL
data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the
RED LED has flashed TWICE.
4. Release the Reset Button. The Broadband Router is now
using the factory default values.
WAN port
(10/100BaseT) Connect the DSL or Cable Modem here. If your modem came
with a cable, use the supplied cable. Otherwise, use a standard
LAN cable.
10/100BaseT
LAN connec-
tions Use standard LAN cables (RJ45 connectors) to connect your
PCs to these ports.
Note:
Any LAN port on the Broadband Router will automatically
function as an "Uplink" port when required. Just connect any
port to a normal port on the other hub, using a standard LAN
cable.
Power port Connect the supplied power adapter here.