ParkerVision WR1500 - Manual (Page 20)

WR1500
4-Port Wireless DSL/Cable Router
®
22
LABEL DESCRIPTION DESCRIPTION
ESSID ESSID Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless LAN.
If you change this fi eld on the WR1500 Wireless Router, make sure all wireless stations use
the same ESSID in order to access the network.
Choose Choose
Channel ID
To manually set the WR1500 Wireless Router to use a channel, select a channel from the To manually set the WR1500 Wireless Router to use a channel, select a channel from the
drop-down list box. Open the Channel Usage Table screen to make sure the channel is not
already used by another AP or independent peer-to-peer wireless network.
To have the WR1500 Wireless Router automatically select a channel, click Scan instead.
Scan Scan Click this button to have the WR1500 Wireless Router automatically scan for and select a Click this button to have the WR1500 Wireless Router automatically scan for and select a
channel with the least interference.
WEP
Encryption
Select Select Disable allows all wireless computers to communicate with the Wireless Routers
without any data encryption.
Select 64-bit WEP or 128-bit WEP to allow data encryption.
Refer to the chapter on wireless LAN for more information.
WIZARD
Back Next
Scan
Wireless
Channel-06 2437MHz
Disable
ASCII Hex
Key 1
Key 2
Key 3
Key 4
64-bit WEP: Enter 5 ASCII characters or 10 hexadecimal characters (”0-9”, “A-F”) for each Key (1-4).
128-bit WEP: Enter 13 ASCII characters or 26 hexadecimal characters (”0-9”, “A-F”) for each Key (1-4).
Select one WEP key as an active key to encrypt wireless data transmission
Wireless LAN Setup
ESSID
Choose Channel ID or
WEP Encryption