Wr1500, Chapter 1 – ParkerVision WR1500 User Manual

Page 6

Advertising
background image

WR1500

4-Port Wireless DSL/Cable Router

®

8

Chapter 1:

Getting to Know Your ParkerVision

WR1500 Wireless Router

This chapter introduces the main features of the ParkerVision WR1500 Wireless Router.

1.1 Introduction

The ParkerVision WR1500 Wireless Router provides wireless connectivity. As an Internet

gateway, your WR1500 Wireless Router can share an Internet connection (through a

cable or xDSL modem) with multiple computers using SUA/NAT and DHCP. The WR1500

Wireless Router offers highly secured wireless connectivity to your wired network with IEEE

802. lx, WEP data encryption and MAC address fi ltering.
The WR1500 Wireless Router is easy to install and confi gure. The embedded web-

based confi gurator and SNMP network management enables remote confi guration and

management of your WR1500 Wireless Router.

1.2 Features of the ParkerVision PC WR1500 Wireless Router
The following are the essential features of the ParkerVision WR1500 Wireless Router .

4-Port Switch
A combination of switch and router makes your WR1500 Wireless Router a cost-effective and

viable network solution. You can connect up to four computers to the LAN ports on your WR150

Wireless Router without the cost of a hub.

10/100M Auto-negotiating Ethernet/Fast Ethernet Interface

This auto-negotiating feature allows the WR1500 Wireless Router to detect the speed of

incoming transmissions and adjust appropriately without manual intervention. It allows data

transfer of either 10 Mbps or 100 Mbps in either half-duplex or full-duplex mode depending on

your Ethernet network.10/100M Auto-crossover Ethernet/Fast Ethernet Interface.

The LAN interface automatically adjusts to either a crossover or straight-through

Ethernet cable. 10/100 Mbps Ethernet WAN.

The 10/100 Mbps Ethernet WAN port attaches to the Internet via broadband modem or

router.

Reset Button

The WR1500 Wireless Router reset button is built into the rear panel. Use this button to restore

the factory default password to 1234; IP address to 192.168.1.1, subnet mask to 255.255.255.0

and DHCP sever enabled with a pool of 8 IP addresses starting at 192.168.1.33.

Brute-Force Password Guessing Protection

The WR1500 Wireless Router has a special protection mechanism to discourage brute-force

password guessing attacks on the WR1500 Wireless Router’s management interfaces. You

can specify a wait-time that must expire before entering a fourth password after three incorrect

passwords have been entered. Please see the appendix for details about this feature.

Advertising