Supplied accessories, Batteries for remote, Before you start 01 – Pioneer DVR-520H User Manual

Page 10: What’s in the box, Putting the batteries in the remote control, Using the remote control

Advertising
background image

Before you start

01

10

En

What’s in the box

Please confirm that the following accessories are in the
box when you open it.

• Remote control

• AA/R6P dry cell batteries x2

• Audio/video cable (red/white/yellow)

• RF antenna cable

• Power cable

• These operating instructions

• Warranty card

Putting the batteries in the remote
control

1

Open the battery compartment cover on the

back of the remote control.

2

Insert two AA/R6P batteries into the battery

compartment following the indications (

,

) inside

the compartment.

3

Close the cover.

Note

Incorrect use of batteries can result in hazards such as
leakage and bursting. Please observe the following:

• Don’t mix new and old batteries together.

• Don’t use different kinds of batteries together—

although they may look similar, different batteries
may have different voltages.

• Make sure that the plus and minus ends of each

battery match the indications in the battery
compartment.

• Remove batteries from equipment that isn’t going to

be used for a month or more.

• When disposing of used batteries, please comply

with governmental regulations or environmental
public instruction’s rules that apply in your country or
area.

Using the remote control

Please keep in mind the following when using the remote
control:

• Make sure that there are no obstacles between the

remote and the remote sensor on the unit.

• Remote operation may become unreliable if strong

sunlight or fluorescent light is shining on the unit’s
remote sensor.

• Remote controllers for different devices can interfere

with each other. Avoid using remotes for other
equipment located close to this unit.

• Replace the batteries when you notice a fall off in the

operating range of the remote.

• When the batteries run down or you change the

batteries, the remote control mode and TV preset
codes are automatically reset. See Remote Control
Set
on page 95 and Setting up the remote to control
your TV
on page 106 to reset them.

• Use within the operating range and angle, as shown.

• You can control this recorder using the remote

sensor of another Pioneer component using the
CONTROL IN jack on the rear panel. See Rear panel
connections
on page 14 for more information.

30

30

23ft

Advertising