Pioneer DVR-520H - Manual (Page 31)

Getting started 04
31
En
Playing CDs and WMA/MP3 discs
The table below shows the basic playback controls for
audio CDs, and WMA/MP3 files.
Note
• If you want to play a DTS audio CD, make sure the
recorder is connected to a DTS-compatible amp/
receiver with a digital connection. Noise will be
output through the analog outputs. Also make sure
that
STEREO is selected using the AUDIO button
(see Switching audio channels on page 43).
• Scanning doesn’t work with WMA tracks.
Playing Video CDs
The table below shows the basic playback controls for
Video CDs.
Some discs feature Playback Control (PBC for short)
menus. These discs show PBC in the display when you
load them and display a menu on-screen from where you
can select what to watch.
Note
• When playing in PBC mode, some playback features,
such as search, repeat and program play are not
available. You can play a PBC Video CD in non-PBC
mode by pressing
to start playback instead of
PLAY.
Press to start playback.
Press to stop playback.
Pauses playback, or restarts playback
when paused.
CD and MP3 only: Press to start scanning.
Press again to increase the scanning
speed. (There are two scan speeds; the
current scan speed is shown on-screen.)
Press to skip to previous/next track (or
folder for WMA/MP3 disc). (You can also
use the front panel
+/– buttons to do this
during playback.)
During playback, enter a track number
then press
ENTER to skip directly to that
track.
Press
CLEAR to clear a number entry and
start again.
PLAY
STOP
PAUSE
REV SCAN FWD SCAN
PREV NEXT
CLEAR
ENTER
Press to start playback.
If
RESUME is displayed on-screen, play-
back starts from the place last stopped.
Press to stop playback.
You can resume playback from the same
point by pressing
PLAY. (Press STOP
again to cancel the resume function.)
Pauses playback, or restarts playback
when paused.
Press to start scanning. Press repeatedly
to increase the scanning speed.
Press to skip to previous/next track. (You
can also use the front panel
+/– buttons to
do this during playback.)
When a PBC menu is displayed, press to
display the previous/next page.
During playback, enter a track number
then press
ENTER to skip directly to that
track.
Press
CLEAR to clear a number entry and
start again.
While a PBC menu screen is displayed,
use to select numbered menu items.
Each press skips backward/forward pro-
gressively up to a maximum of 10 minutes
forward or three minutes back. Note that
this function doesn’t work when playing in
PBC mode.
During playback, press to start slow-
motion playback. Press repeatedly to
change the playback speed.
While paused, press to advance a single
frame (forward direction only).
Press to display the disc menu of a Video
CD playing in PBC mode.
PLAY
STOP
PAUSE
REV SCAN FWD SCAN
PREV NEXT
CLEAR
ENTER
SKIP CM BACK
STEP/SLOW
RETURN