On screen display on / off, Front panel display on / off, Remote control command mode – Pioneer DVR-520H User Manual

Page 95: Setup navigator on / off, Tuner settings, Auto channel setting antenna / cable, The initial setup menu 13, On screen display, Front panel display, Remote control set

Advertising

The Initial Setup menu

On Screen Display

• Default setting:

On the default setting, the recorder shows on-screen
operation displays (

Play, Stop and so on). Change to Off

to hide these displays.

Front Panel Display

• Default setting:

On the default setting, the time is shown in the front
panel display when the recorder is in standby. Switch to
Off to have the front panel display switch off completely
when in standby.

Note

• When set to

Off, the display still lights dimly in

standby when setting a timer recording, or during
Auto Start Recording.

Remote Control Set

• Default setting:

Recorder1

You only need to set this if you are using more than one
Pioneer DVD recorder in the same room.

So that each remote control operates only its own
recorder, make this setting different for each recorder
and remote in the room.

There are three different recorder IDs. When set to
Recorder2 or Recorder3, the remote control mode is
shown in the front panel display.

After selecting a new recorder ID, you have to confirm the
change by selecting

Yes or No (use the

/ (cursor

left/right) buttons), then pressing

ENTER.

Note that as soon as you change the recorder ID, the
remote becomes inoperative until you change the remote
to the same ID.

To set the remote, press and hold

RETURN and a number

button (

1, 2 or 3) until the indicator on the remote lights.

Setup Navigator

• Default setting: n/a

The Setup Navigator appears automatically when you
switch on the recorder for the first time (or after resetting
the recorder). It is also available from the Initial Settings
menu should you need it at any other time.

See also Switching on and setting up on page 25.

Tuner settings

Auto Channel Setting

• Default setting:

Antenna

Auto Channel Setting automatically tunes the built-in TV
tuner to terrestrial broadcast TV channels or cable
channels. Select

Antenna or Cable, depending on how

you receive your TV channels, then wait for the automatic
tuning to finish.