Paradise RA 5785 - Manual (Page 26)

26 208143 REV - Operations Manual, HPA3, Mini Compact Outdoor SSPA
If using Windows 7 or Windows Vista:
1. Click on the Windows icon in the lower left corner and select Control Panel;
2. Click on the Network and Sharing Center link;
3. Click on the Local Area Connection link;
4. Click on the Properties button;
5. Select Internet Protocol Version 4 (TCP/IP v4) and click on the Properties button;
6. Select “Use the following IP address” and enter the following information:
IP address: 192.168.0.1
Subnet mask: 255.255.255.0
6. Click the “OK” button and close out of all of the Control Panel windows.
3.2.2 Quick Start Ethernet Connection
The following steps outline how to quickly connect to your Compact Outdoor SSPA using the
Ethernet Quick Start cable.
1. Unpack the amplifier and connect the RF Input and RF Output.
2. Ensure the J1 RF Output port is properly terminated.
3. Connect the AC input power to connector J7.
4. When shipped from the factory, the Mini Compact Outdoor SSPA is set to
start up muted.
5. Connect the supplied “Quick-Start” Control Cable from Port J4 to the Ethernet port
on your computer. This connection will unmute the amplifier. Review the cable
schematic in Figure 3-4.
6. Launch the Windows-based Paradise Datacom Universal M&C Software.
NOTE: If the Mini Compact Outdoor unit is powered up with the Ethernet Quick Start
Cable connected to Port J4, the following default conditions apply to the unit:
• IPNET Interface
• Gateway: 192.168.0.1
• IP Address: 192.168.0.9
• Subnet Mask: 255.255.255.0
• Local Port: 1007
• IP Lock: 255.255.255.255
• Web password: paradise
• Read Community: public
• Write Community: private
• Amplifier is un-muted