Paradyne 7510-A2-GB20-00 727 - Manual (Page 44)

6-1 7510-A2-GB20-00 March 1997
Messages and Troubleshooting
6
Messages and Troubleshooting
There are many messages available to assess the status of the device and
contribute to problem resolutions. Refer to the following sections:
H Responding to Device Messages
H Troubleshooting
Responding to Device Messages
The Device Messages in Table 6-1, listed in alphabetical order, may appear in the
messages area at the bottom of the ATI screens.
Table 6-1. Device Messages (1 of 2)
Device Message What Message Indicates What To Do
Command Complete Action requested has
successfully completed. No action needed.
Invalid Character x A nonprintable ASCII
character has been
entered. Reenter information using valid
characters.
Invalid – Network
Initiated CSU (or DSU)
Loopback Active Network-initiated loopback
was in progress when
another selection was
made. No action needed.
Invalid – [ Test ]
Already Active [Test] can be a CSU, DSU,
or DTE Local Loopback, or
a Send 511 or Monitor 511.
The [test] was already in
progress when another
selection was made. H Allow test to continue.
H Select another test.
H Stop the test.