Pioneer Elite DV-48AV - Manual (Page 56)

Additional information 09
56
En
Cannot play multi-
channel audio. • Make sure that Audio Output Mode is set to 5.1 Channel
(page 45).
• Check that the Dolby Digital, DTS and MPEG Out settings (page 39)
are suitable for your amplifier/receiver — check the instruction manual
that came with your amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital audio.
Listen through the player’s analog outputs.
• Check that the settings in the Speaker Installation screen are correct
(page 50).
• Check the audio options available from the disc menu.
Cannot listen to high-
sampling rate audio
through the digital
output. • Make sure that Linear PCM Out is set to Down Sample Off
(page 39).
• As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if set to
Down Sample Off, the player
automatically outputs the audio at 48 kHz. This is not a malfunction.
Cannot output 192 kHz or
176.4 kHz digital audio. • The player does not output digital audio at these sampling rates. The
digital output is automatically downsampled.
Cannot output 96 kHz or
88.2 kHz digital audio. • Check that Linear PCM Out is set to Down Sample Off (page 39).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
No DTS audio output. • If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set
DTS Out to DTS > PCM
(page 39). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that the
cable is properly connected.
Audio mix does not
sound right or sounds
incomplete (for example,
inaudible dialog). • Make sure that Audio Output Mode is set to 2 Channel if you’ve
connected to the stereo inputs on your amplifier or TV (page 45).
Can’t hear effect of
Virtual Surround. • Virtual Surround does not work with SACD or DVD-Audio.
• The Virtual Surround effect is only output through the
AUDIO OUT
(2ch) analog audio outputs.
• Make sure that
Audio Output Mode is set to 2 Channel (page 45).
• The effectiveness of Virtual Surround varies with the disc.
Problem Remedy
DV48AV_EN.book 56 ページ ２００７年６月６日 水曜日 午前１０時２分