Planet Technology 23x Indoor Speed Dome Camera CAM-ISD48 - Manual (Page 27)

2. With outdoor housing, AC24V:
An AC adapter of 24V / 1.66A is supplied with the outdoor housing (CAM-OH)
for the AC version. To power the camera, connect adapter to camera’s power
connector.
. .
User’s manual 27
Power Connector on Speed Dome AC 24V Connector on Adaptor
As soon as power is supplied, the speed dome will enter “initial check” mode with
the following procedures:
„
Move the lens automatically for system check
„
Screen comes up with blue picture and will be showing “starting” in white
for around 3 seconds
„
Then the camera will show normal image and get ready for control
6.2 Video
Video output level of the camera, in standard of 1Vp-p, is delivered with female
BNC connector at 75 ohms impedance. To transmit the video to receiver properly, it
is recommended to use RG-59 A/U coaxial cable with stranded center conductor,
with male BNC connectors on both ends.
RG-59 is also in 75 ohm impedance, which matches the
camera’s output impedance. The A/U version is
recommended, rather than the version B/U, due of its
superior performance on flexibility for resisting severe
twisting, bending and other stresses which occur in many
CCTV installations.
In case the installation distance is over than 500 meters (1,500 feet), additional
amplifier might be needed to keep the video level and image quality.