Panasonic KX-FP145AL - Manual (Page 49)

8. Programmable Features
47
8.2 Basic features
Code #01: Setting the date and time
SET DATE & TIME
PRESS SET
See page 18 for details.
Code #02: Setting your logo
YOUR LOGO
PRESS SET
See page 19 for details.
Code #03: Setting your fax number
YOUR FAX NO.
PRESS SET
See page 20 for details.
Code #04: Printing a sending report
SENDING REPORT
=ERROR [ ±]
To print a sending report for fax transmission
results (page 27).
“
ERROR” (default): A sending report will be
printed only when fax transmission fails.
“
ON”: A sending report will be printed out after
every transmission.
“
OFF”: Sending reports will not be printed out.
Code #06 (KX-FP141 only): Changing the ring
setting in FAX ONLY mode
FAX RING COUNT
RINGS=2 [ ±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select from “
2” (default), “3”, “4”, “5”, “6”,
“ 7”, “8”, “9”. If you are using the unit with an
answering machine, set to more than 4 (page
33).
Code #06 (KX-FP145 only): Changing the ring
setting in TAD/FAX mode
TAD RING COUNT
RINGS=2 [ ±]
To change the number of rings before the unit
answers a call in TAD/FAX mode. You can select
“
2” (default), “3”, “4”, “5”, “6”, “7”, “8”, “9”, “TOLL
SAVER” or “RINGER OFF”. See page 32 for
details.
Note:
L Set feature #77 to “ TAD/FAX” (page 51)
beforehand.
Code #06 (KX-FP145 only): Changing the ring
setting in FAX ONLY mode
FAX RING COUNT
RINGS=2 [ ±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select “
2” (default), “3”, “4”, “5”, “6”, “7”,
“ 8” or “9”.
Note:
L Set feature #77 to “ FAX ONLY” (page 51)
beforehand.
Code #10 (KX-FP145 only): Changing the
maximum incoming message recording time
RECORDING TIME
=VOX [ ±]
“ VOX” (default): Unlimited.
“ 1 MIN”–“9 MIN”: 1 minute to 9 minutes.
Code #11 (KX-FP145 only): Setting the
remote operation ID
REMOTE TAD ID
=ON [ ±]
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. Press {A} or {B} repeatedly to select “ ON”.
4. Press {SET}.
5. Enter any 3-digit number except a number
using 0 or 7.
L The default ID is “ 222”.
6. Press {SET}.
7. Press {MENU}.
Code #13: Setting the dialling mode
(For Australian users only)
DIALLING MODE
=TONE [ ±]
If you cannot dial, change this setting depending
on your telephone line service.
“
TONE”(default): For tone dial service.
“ PULSE”: For rotary pulse dial service.
Code #17: Setting the ringer pattern
RINGER PATTERN
=A [ ±]
You can select “ A” (default), “B” or “C”.
FP141-145AL.book Page 47 Tuesday, October 21, 2003 11:07 AM