Panasonic KX-FP145AL - Manual (Page 53)

8. Programmable Features
51
Code #70 (KX-FP145 only): Calling your
pager
PAGER CALL
=OFF [ ±]
See page 45 for details.
Code #74: Setting the location where you use
this unit
LOCATION
=AUSTRALIA [ ±]
This setting must match your location.
“
AUSTRALIA” (default): To use in Australia.
“ NEWZEALAND”: To use in New Zealand.
Code #76: Setting the connecting tone
CONNECTING TONE
=ON [ ±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones;
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party’s machine.
“
ON” (default): You will hear connecting tones.
“ OFF”: Deactivates this feature.
Note:
L If the ring back tone continues, the other
party’s machine may not be a facsimile or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
Code #77 (KX-FP145 only): Changing the
receiving mode in the auto answer setting
AUTO ANSWER
=TAD/FAX [ ±]
“ TAD/FAX” (default): Telephone Answering
Device/Facsimile mode (page 32)
“
FAX ONLY”: Facsimile only mode (page 32)
Code #80: Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO [ ±]
To reset the advanced features:
1. Press {MENU}.
2. Press {#}, then {8}{0}.
3. Press {A} or {B} repeatedly to select “ YES”.
4. Press {SET}.
5. Press {SET} again.
6. Press {MENU}.
Note:
L ECM selection (feature #68, page 50) and
the location setting (feature #74, page 51) will
not be reset.
FP141-145AL.book Page 51 Tuesday, October 21, 2003 11:07 AM