Pelikan 9CH - Manual (Page 28)

28
Note: For speed dome cameras that support RS-485, connect them directly to the RS-485 port.
If the camera is controlled with RS-232C, use an RS-485 to RS-232C signal converter.
On the PTZ control Setup screen, you can select or set the protocol type of the camera that is
the same as the one installed on the site. If the camera has a specific camera ID, select the
camera ID using the LEFT and RIGHT arrow controls.
The following options are available on the PTZ control screen.
CHANNEL (channel number that the PTZ is connected to)
NAME (protocol type)
SPEED (19200, 14400, 9600, 4800, 2400)
ID (0-63)
3-4-4. Motion Zone Setup
When you select Partial Zone in the Motion Zone menu, you can set-up the motion sensing
zones in the screen. To move around each rectangular zone, use the arrow controls. Press the
SEL button on each rectangular zone you want to include as part of the motion sensing zone.
As you select each zone, the color changes. Press ESC button to return to the DEVICE menu.
Figure 3.4.5. Motion Zone selection screen