Pioneer PDP-5080HD - Manual (Page 20)

20
En
Preparation 05
When using the hung on wall unit:
Note
• First lay the plasma display on top of a soft sheet etc., remove
the stand, then attach the speaker mounting fittings.
1 Attach the speaker mounting fittings to the rear
of the plasma display (See procedure 1 on page 17.
2 Connect the supplied speaker cables to the rear of
the plasma display (See procedure 4 on page 19).
3 Place the plasma display on the mounting fittings
of the hung on wall unit.
For details, refer to the instruction manual supplied with the
hung on wall unit.
Caution
• Be careful about the speaker mounting fittings when installing
or connecting. This may result in injury.
4 Connect the other end of the speaker cables to the
speaker (See procedure 5 on page 19).
Caution
• Have two people perform this procedure.
5 Fit the speaker to the mounting fittings the correct
direction.
Caution
• Be sure not to mount the speaker upside down.
6 Tighten from below using the supplied screws
(three locations).
• Tighten the three screws in order 1, 2, 3 as shown in the
diagram.
The screw hole at the rear surface of the speaker mounting
fitting is used when the plasma display is installed with the
table top stand. It is not used when installed with the
stand.
Note
• If after attaching the speaker its position needs to be adjusted
horizontally, first loosen the speaker mounting screws,
reposition and then tighten the screws again at the appropriate
position.
7 Bundle the cables (See procedure 6 on page 19).
3
1
2
Speaker mounting screw
(M5 x 10 mm)
When using the hung on wall
unit, do not use this hole.
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm)
PDP5080HD.book Page 20 Monday, April 9, 2007 7:49 PM