Panasonic NV-VP30EBL - Manual (Page 35)

To manually adjust the clock
On Screen Display.
The clock will normally be set correctly during Auto-Setup however, in some
circumstances the VCR cannot set the clock automatically. In this case, follow
the operation steps below to manually set the clock.
!
!
!
!
!
! Press and select Clock set .
Press .
Confirm that Clock set is set to MANUAL, and press .
Use or buttons to set the Date and Time.
Press to conclude the settings.
Press to exit the On Screen Display.
MENU
ENTER
ENTER
Numeric
ENTER
EXIT
To activate the automatic time correction function
The correct time for the VCR clock can be automatically maintained when the
VCR is tuned to a station that transmits a time signal.
-
-
-
-
If Clock setting is set to AUTO when you open the Clock screen, do not set it to
MANUAL, otherwise, the automatic time correction function is deactivated.
This VCR uses a 24 hour clock.
In case of a power failure, an automatic back-up system maintains the clock for
approximate 60 minutes.
When Clock setting is set to AUTO, the automatic time correction function checks and if
necessary adjusts the time several times every day. The automatic time correction
function only works when the VCR is in standby, it does not work in the timer recording mode.
!
!
!
!
!
Press and select Clock set .
Press .
Use to set AUTO.
Press to conclude the setting.
Under adverse reception conditions, etc., the Automatic time correction
function may not work. In this case, the indication for Clock setting is
automatically reset to MANUAL. If the reception conditions improve later on, it
may be possible to activate this function.
Press
to exit the On Screen Display.
MENU
ENTER
ENTER
EXIT
Notes:
Clock setting
Menu
Timer recording
Tuning
Clock set
Others
:select : access
: exit
ENTER
EXIT
Datum / Zeit Clock set
Time : 12 : 00 : 00
Date : 11. 6. 03
MANUAL
Datum / Zeit Clock set
Time : 12 : 00 : 00
Date : 11. 6. 03
AUTO
DVD
TV
VCR
35
VCR DVD