Pioneer RDS DEH-P40MP - Manual (Page 35)

Adjusting initial settings
1 1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press SOURCE and hold again until
function name appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press
FUNCTION repeatedly to switch be-
tween the following settings:
FM (FM tuning step)
—A-PI (auto PI seek)—
AUX1 (auxiliary input 1) —AUX2 (auxiliary
input 2)
—R-SP (rear output and subwoofer
controller)
—TITLE (multi language)—SAVE
(power save)
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down
SOURCE until the unit turns off.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
! The tuning step remains at 50 kHz during
manual tuning.
1 Press FUNCTION to select FM.
2 Press c or d to select the FM tuning
step.
Press c to select 50 (50 kHz). Press d to se-
lect
100 (100 kHz).
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Press FUNCTION to select A-PI.
2 Press a or b to turn A-PI on or off.
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 37.
1 Press FUNCTION to select AUX1/AUX2.
2 Press a or b to turn AUX1/AUX2 on or
off.
Other Functions
En
35
English
Section
10