Pioneer RDS DEH-P40MP - Manual (Page 36)

Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
R-SP :FUL) or subwoofer
( R-SP :S/W) connection. If you switch the rear
output setting to R-SP :S/W, you can connect
a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
R-SP :FUL). When rear output is
connected to full range speakers (when
R-SP :FUL is selected), you can connect other
full range speakers (
P/O :FUL) or a subwoofer
( P/O :S/W) to the RCA rear output.
1 Press FUNCTION to select R-SP.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
R-SP :FUL (full-range speaker) and R-SP :S/W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select
R-SP :FUL.
# When a subwoofer is connected to the rear
output, set for subwoofer
R-SP :S/W.
# When the rear output setting is R-SP :S/W,
you cannot operate the following procedure.
3 Press c or d to switch the subwoofer
output or rear output.
Pressing c or d will switch between P/O :S/W
and
P/O :FUL and that status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
33).
! If you change this setting, subwoofer output
in the audio menu return to the factory
settings.
Multi language display setting
Text information such as title name, artist
name or comment can be recorded on a
WMA/MP3/WAV disc.
This unit can display them even if they are em-
bedded in either European language or Rus-
sian language.
! If embedded language and selected lan-
guage setting are not consistent with each
other, text information may not be dis-
played properly.
! Some characters may not be displayed
properly.
1 Press FUNCTION to select TITLE.
2 Press c or d to select the language.
EUR (European language)
—RUS (Russian
language)
Saving the battery
consumption
Switching this function on enables you to save
the consumption of battery power.
! Operations other than turning on the
source are not allowed when this function
is on.
Important
If the battery in your vehicle is disconnected the
Power Save mode is canceled. Turn on Power
Save again once the battery has been recon-
nected. If the ignition switch in your vehicle
doesn
’t have an ACC (accessory) position, it is
possible depending on the connection method
that when Power Save is off, the unit will draw
power from the battery.
1 Press FUNCTION to select SAVE.
2 Press a or b to turn the power save on
or off.
Other Functions
En
36
Section
10