Panasonic DMR-EZ28 - Manual (Page 54)

54
RQT9046
4:3 TV settings for DVD-Video
You can select how to display the image on the TV
when you watch 16:9 images (DVD-Video) on a 4:3
standard aspect TV.
Perform step 1 of “Accessing the Setup Menus” (
➔ 46).
e, r to select “TV Screen”, then q
e, r to select “4:3 TV settings for
DVD-Video”, then
e, r to select “Pan and Scan
(Stretch to fit)” or “Letterbox (Shrink
to fit)”, then
[Pan and Scan (Stretch to fit)]
Video recorded for a widescreen is played with the
sides cut off if Pan & Scan was specified. If 16:9
software prohibits Pan & Scan, the image will appear
in the letterbox style (with black bands above and
below the picture) despite the setting here.
[Letterbox (Shrink to fit)]
Video recorded for a widescreen is played in the
letterbox style.
4:3 TV settings for DVD-RAM
You can select how to display the image on the TV
when you watch 16:9 images (DVD-RAM) on a 4:3
standard aspect TV.
Perform step 1 of “Accessing the Setup Menus” (
➔ 46).
e, r to select “TV Screen”, then q
e, r to select “4:3 TV settings for
DVD-RAM”, then
e, r to select “4:3”, “Pan and Scan
(Stretch to fit)” or “Letterbox (Shrink
to fit)”, then
[4:3] Recordings are played
as recorded.
[Pan and Scan (Stretch to fit)] Video recorded for a
widescreen is played
with the sides cut off.
[Letterbox (Shrink to fit)] Video recorded for a
widescreen is played in
the letterbox style.
Component Output Signal
If you connected this unit and a TV with component
video cables, select the item compatible with the
connected equipment.
Perform step 1 of “Accessing the Setup Menus” (
➔ 46).
e, r to select “TV Screen”, then q
e, r to select “Component Output
Signal”, then
e, r to select “480i”, “480p”, “720p”
or “1080i”, then
[720p], [1080i]: Videos from DVD-Video are output with
480p, irrespective of the settings.
If the video is distorted when the settings are
changed, then press and hold [g] and [q] on the main
unit for 5 seconds or more to set it back to [480i].
If this unit is connected to an amplifier via an HDMI
cable and audio is not output when these settings are
changed, then use a non-HDMI cable to connect the unit.
If this unit is connected to an amplifier, etc. via an
HDMI cable with “HDMI Priority” set to “On”, the video
will be fixed to 480i. Turn it “Off” and set it again.
If the “TV Aspect” is set to “4:3” (
➔ 53), then “480i” or
“480p” can only be selected.
Functions of HDMI
Perform step 1 of “Accessing the Setup Menus” ( ➔ 46).
e, r to select “TV Screen”, then q
e, r to select “Functions of HDMI”,
then
HDMI Priority
After selecting “Functions of HDMI” ( ➔ above, step 3)
e, r to select “HDMI Priority”, then
e, r to select “On” or “Off”, then
[Off] When connecting equipment such as an
amplifier with an HDMI cable and connecting
TV (compatible with progressive video) with a
Component Video Cable
•
•
•
•
Setup Menus