Panasonic DMR-EZ28 User Manual
Page 71
71
RQT9046
Ref
erence
General Issues
Operation
Page
Cannot operate the TV or Set
Top Box with the unit’s remote
control.
Change the manufacturer code on the remote control.
•
56
Select TV or Set Top Box mode on the remote control.
•
56
The remote control doesn’t
work.
The remote control code is wrong. Change to the correct code.
•
48
The batteries are depleted. Replace them with new ones.
•
5
Point the remote control at the remote control sensor on the main unit.
•
5
Remove obstacles between the remote control and main unit.
•
−
Remove dust from the transmission window and the unit’s sensor.
•
−
Colored glass may obstruct the signal reception/transmission.
•
−
Don’t place the signal sensor in direct sunlight or in areas that may be
subject to sun exposure.
•
−
It may be necessary to set the code on the remote control again after
changing the batteries.
•
48
It may be necessary to set the manufacturer code again after
changing the batteries.
•
56
The unit is on but cannot be
operated.
Some operations are prohibited by the disc.
•
−
The unit is warm (“U59” appears on the unit’s display). Wait until “U59”
disappears.
•
−
One of the unit’s safety devices may have been activated.
Reset the unit as follows:
Press [POWER 8] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit (
➔ 70, “To restore the
unit if it freezes”).
•
−
“U88” is displayed and the disc
cannot be ejected.
The unit is carrying out the recovery process. Do the following to eject the disc:
(1) Press [POWER 8] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit (
➔ 70, “To restore the
unit if it freezes”).
(2) While the unit is off, press and hold [g] and [CH 1] on the main unit
at the same time for about 5 seconds. (Ejection may take extra time
depending on discs.) The disc may be defective. Try another disc.
•
−
Cannot eject a disc.
The unit is recording.
•
−
The unit may have a problem. Eject the disc as in (2) above.
•
−
Startup is slow.
Startup takes time in the following situations:
A disc other than a DVD-RAM is inserted.
The clock is not set.
Immediately after a power failure or the AC power supply cord is
connected.
When the unit is connected with an HDMI cable.
•
–
–
–
–
−
A password screen appears
and you are unable to view or
record.
If the unit starts receiving a broadcast with the set rating information,
a password screen appears and you will be unable to view or record.
Enter your password to continue.
•
47
Time is incorrect after using
Auto Clock Setting.
Try again. If the time is still incorrect, set the clock manually.
•
49
Cannot set “24p Output for
DVD-Video”.
Only when the unit is connected to the HDMI terminal of a TV
supporting 24p, you can set “24p Output for DVD-Video”. In some
cases where the unit is connected to a TV via an amplifier/receiver
through the HDMI terminals, you may not be able to set it. In this
case, connect the unit to a TV through the HDMI terminal and
connect it to the amplifier/receiver through any terminal other than
HDMI.
•
55