Perfect Flame 720-0522 - Manual (Page 20)

Fig. 22
Searing Side Burner
1. If you have already attempted to light the searing side
burner with the igniter, allow 5 minutes for any accumulated
gas to dissipate.
2. Insert a match into the lighting rod (A) as shown in fig.22.
Ignite the match and insert through the cooking grids (B) to
the burner.
3. Press the control knob and rotes to the “HI” setting, continue
to press the knob until the burner ignites. The burner should
light immediately.
4. If the burner does not light within seconds turn the knob to
the “OFF” position, wait 5 minutes and try again.
Rotisserie Burner
Note: Remove the warming rack when using a match to light
the rotisserie burner.
1. If you have already attempted to light the rear rotisserie
burner with the igniter, allow 5 minutes for any accumulated
gas to dissipate.
2. Insert a match into the lighting rod (A) as shown in fig. 23.
Ignite the match and hold next to the burner (B).
3. Press the control knob and rotate to the “HI” setting. Once
the burner ignites, continue to press the knob for 15
seconds.
4. If the burner does not light within seconds turn the knob to
the “OFF” position, wait 5 minutes and try again.
Halogen Lights
Light Operation Instructions
1. Make sure the light power switch on the control panel is in the “OFF” position
2. Connect power plug to properly grounded outlet.
3. Turn the light power switch to “ON”.
Halogen Bulb Replacement
1. Make sure that the grill has cooled before changing the light
bulb.
2. Make sure the light’s power switch on the control panel is in
the “OFF” position and power plug is disconnected from the
outlet.
3. Use a Phillips screwdriver to loosen the screw securing the
light.
Fig. 23
B
WARNING
Keep any electrical supply cord away from any heated surface.
A
A
B
20