Perfect Flame 720-0522 - Manual (Page 21)

4. Remove the light bulb housing.
5. Remove the glass cover from the light bulb housing.
6. Use a flathead screwdriver to loosen the two screws locking
the bulb in place. Pull out the light bulb and replace with a
new bulb. Tighten the two screws. Note: Do not touch the
halogen bulb with bare hands.
7. To re-install the light, replace the glass cover, insert the light
bulb housing into the grill and insert and tighten the screw.
Cleaning Method
Follow steps 1 thru 4 above for glass cover removal. Use a damp towel to clean the surface of the glass
cover. Make sure the glass cover is completely dry before re-installing.
WARNING
Make sure the light switch is in the “OFF” position and the power plug is disconnected from
the power outlet prior to cleaning the glass cover.
WARNING
21
The light glass cover should not be in contact with water or any other liquid when it’s warm.
Sudden change of temperature may cause cracks on the glass cover.