Perfect Flame 720-0522 - Manual (Page 22)

Bulb Specification
Bulb Type: Halogen
Wattage: 10 watts per bulb
Voltage: 12 volts
Please contact customer service at 1-800-323-5263 for assistance on bulb replacement information.
CARE AND MAINTENANCE
WARNING
To ensure continued protection against electric shock:
1. Connect to properly grounded outlets only.
2. Do not expose to rain.
3. Keep extension cord connections dry and off the ground.
Stainless Steel
There are many stainless steel cleaners available. Always use the mildest cleaning process first,
scrubbing in the direction of the grain. Do not use steel wool as it will scratch the surface. To touch up
noticeable scratches in the stainless steel, sand very lightly with dry 100 grit sand paper in the direction of
the grain.
Grease specks can gather and bake onto the surfaces of the stainless steel, giving the appearance of rust.
For removal, use an abrasive pad with a stainless steel cleaner.
Cooking Grates
The easiest way to clean the grill is immediately after cooking is completed and the flames have been
turned off.
Wear a barbeque mitt to protect your hand from heat and steam.
Scrub the hot cooking grates by dipping a bristled barbecue brush in tap water. Cleaning will be more
difficult if the grill is allowed to cool.
Grease Pan
The grease pan should be emptied, wiped down and washed after each use with a mild detergent and
warm water solution. Check the grease pan frequently and do not allow excess grease to accumulate and
flow out of the grease pan.
Searing Side Burner
Clean the exterior of the burner with a wire brush. Clear any clogged burner ports with a straightened
paper clip. Never enlarge the burner ports. Never use a wooden toothpick as it may break off and clog the
port.
Grill Burners
Extreme care should be taken when removing a burner. It must be correctly centered on the orifice
before any attempt is made to relight the grill. Frequency of cleaning will depend on how often you use
the grill.
Failure to properly place the burner over the orifice could cause a fire to occur behind and beneath the
valve panel, thereby damaging the grill and making it unsafe to operate.
Before cleaning, make sure the gas supply and control knobs are in the “OFF” position and the burners
have cooled.
22