Perfect Flame 720-0522 - Manual (Page 9)

Fig. 2
2. Side Panel Assembly
B
Loosen, but do not remove, the six 1/4-in. x 15-mm truss
head screws on the bottom panel (A) as shown in fig. 2.
Insert the screw and locking washer into the keyhole slot
located on the bottom of the left side panel (B). Position the
left side panel flush with the rear of the bottom panel and
tighten the screws.
C
Repeat steps for the right side panel (C).
A
Fig. 3
3. Back Panel Assembly
Remove the back panel from the carton. Position the back
panel (A) with the flat side facing outward. Attach the back
panel to the bottom panel (B) with
three 1/4-in. x 15-mm truss
head screws from pack C and three 1/4-in. locking washers
from pack D as shown in fig. 3.
A
B
Fig. 4
Back and Side Panel Assembly
Use four 1/4-in. x 15-mm truss head screws from pack C and
four 1/4-in. locking washer from pack D to connect the back
panel (A) to the right and left side panels (B) as shown in fig. 4.
A
B
9