Panasonic AJ-HD150 - Manual (Page 67)

– 67 –
USER menu
<VIDEO>
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
600 VIDEO IN 0000 INT SG
SEL 0001 SDI
0002 SDTI
601 VIDEO INT 0000 OCB
SG 0001 MB
0002 RAMP
0003 BLACK
602 SDI IN 0000 DR OFF
MODE 0001 DR ON
603 V-MUTE 0000 N-MUTE
SEL 0001 GRAY
0002 BLACK
0003 NOISE
604 FREEZE 0000 FIELD
SEL 0001 FRAME
605 INTERPOLATE 0000 OFF
0001 AUTO
620 DOWNCON 0000 FIT_V
MODE 0001 FIT_H
0002 FIT_HV
0003 14:9
0004 13:9
621 UPCON 0000 FIT_V
MODE 0001 FIT_H
0002 FIT_HV
0003 14:9
0004 13:9
622 DC RESP 0000 WIDE
HV 0001 STAND
0002 NARROW
623 UC RESP 0000 WIDE
HV 0001 STAND
0002 NARROW
The underline on the setting item denotes the initial setting.
This selects the video signals to be input.
0: The internal signals selected by the VIDEO INT SG menu
item are generated.
1: The serial video signals supplied to the HD SDI IN
connector are selected.
2: The compressed IF signals supplied to the SDTI IN
connector are selected.
This selects the type of internal signals.
0: The color bar signal is selected.
1: The multi burst signal is selected.
2: The ramp signal is selected.
3: The black signal is selected.
This selects the HD SDI input processing method.
0: After the lower 2 bits have been rounded off (rounded up
for 5 or above, rounded down for 4 or below), the higher 8
bits are recorded.
1: The 8-bit signals which have been dynamically rounded are
recorded.
This selects whether to mute the video output signals when
LOW RF has been detected during playback.
0: The signals are not muted. (They are frozen.)
1: They are muted with gray.
2: They are muted with black.
3: They are muted with noise.
This selects the freeze status for still pictures.
0: Field freeze
1: Frame freeze
Vertical interpolation is automatically conducted during slow
playback to reduce the vertical movement of the playback
pictures, but this setting enables the interpolation to be forcibly
turned off.
0: Interpolation is forcibly turned off.
1: Interpolation is automatically turned on during slow
playback.
This selects the screen during down-conversion.
0: Side cut mode
1: Letterbox mode
2: Squeeze mode
3: Semi-letterbox 14:9
4: Semi-letterbox 13:9
This selects the screen during up-conversion.
0: Side panel mode
1: Top and bottom in vertical direction cut off
2: Stretch mode
3: Semi-letterbox 14:9
4: Semi-letterbox 13:9
This selects the horizontal and vertical frequency band during
down-conversion.
This selects the horizontal and vertical frequency band during
up-conversion.
<Note>
Setup menu items
No.620 to No.623 do
not work if the AJ-
UDC150P optional
board has not been
installed.
Setup menus