Panasonic AJ-HD150 - Manual (Page 98)

– 98 –
Connector signals
PARALLEL REMOTE (50P)
Pin No. Signal Pin No. Signal Pin No. Signal
1 REC COMMAND 23 CUE COMMAND 34 ERR 2 STATUS*
2 PLAY COMMAND 24 ERR 1 STATUS* 41 CUE STATUS
3 FF COMMAND 26
+
POWER 42 REMOTE STATUS
4 REW COMMAND 27 REC STATUS 46 STBY STATUS
5 STOP COMMAND 28 PLAY STATUS 47 GND
11 EJECT COMMAND 29 FF STATUS 49 GND
12 IN SET COMMAND 30 REW STATUS 50 GND
20 STBY ON/OFFCOMMAND 31 STOPSTATUS
21 ERR 0 STATUS* 33 EJECT STATUS
*50-pin error status table
RS-232C REMOTE (25-pin D-SUB crossover cable supported)
Pin No. Abbreviation Circuit Description
1 FRAME GROUND Protective ground Frame ground
2 RxD Received data Sends data to the PC.
3 TxD Transmitted data Receives data from the PC.
4 CTS Clear to send Shorted with pin 5.
5 RTS Request to send Shorted with pin 4.
6 DTR Data terminal ready No processing
7 GND Signal ground Signal ground
20 DSR Data set ready
Positive power output after communication
enable status
ENCODER REMOTE (15P)
Pin No. Signal
1 FRAME GROUND
2 REM (G)
3 REM REX (X) REMOTE CONTROL PROTOCOL RECEIVE
4 REM REX (X) REMOTE CONTROL PROTOCOL TRANSMIT
5 REM REX (Y) REMOTE CONTROL PROTOCOL RECEIVE
6 REM REX (X) REMOTE CONTROL PROTOCOL TRANSMIT
Pin21/
ERROR 0
0
0
0
0
1
1
1
1
Pin24/
ERROR 1
0
0
1
1
0
0
1
1
Pin 34/
ERROR 2
0
1
0
1
0
1
0
1
Output priority
sequence
1
4
3
2
----
----
----
----
AJ-HD150
VTR status
SERVO NOT LOCKED
SEVO LOCKED
HIGH ERROR (UMBER)
HIGH ERROR (RED)