Psion Teklogix Vehicle-Mount Computer 8515 - Manual (Page 38)

Chapter 2: Basic Checkout
Assigning The IP Address
18 Psion Teklogix 8515 Vehicle-Mount Computer User Manual
2.8.1 Assigning The IP Address
Before launching the SCU, you need to configure how the IP address will be obtained.
•
Tap on Start>Settings>Network and Dial-up Connections.
Follow the steps under the heading “Assigning An IP Address” on page 15 to determine
how the IP address will be obtained—either via DHCP or by specifying an address.
2.8.2 Using The SCU To Connect To The WLAN
This section provides a quick set of steps to create a profile (referred to as a config). Detailed
information about each of the SCU tabs—Main, Config, Status, Diags and Global Set-
tings—is provided under
“SCU Tabs” beginning on page 20 .
To launch the SCU so that your vehicle-mount can connect to a wireless LAN:
•
Tap on Start>Programs>Summit>SCU.
Figure 2.11 SCU Main Menu
• Tap on the Config tab.
Figure 2.12 SCU Configuration Menu
Note: You do not need to reset your 8515 after configuring the Summit DC 802.11
SC (Model RA2041) CF radio.
Radio
Attributes