Psion Teklogix Vehicle-Mount Computer 8515 - Manual (Page 45)

Chapter 2: Basic Checkout
Global Settings Tab
Psion Teklogix 8515 Vehicle-Mount Computer User Manual 25
2.9.2.2 EAP Credentials
Keep the following in mind when defining security settings:
•
If the credentials specified in the config are incorrect and that config is used, the authen-
tication fails without an error message; you will not be prompted to enter
correct credentials.
• If the credentials are not specified in the config, when the radio tries to associate using
that config, you will be prompted to enter the credentials.
• When prompted, you can enter valid credentials, enter invalid credentials, or cancel
the operation.
- If you enter valid credentials and tap OK, the radio will associate and authenticate.
- If you enter invalid credentials and tap on OK, the radio will associate but will not
authenticate; you will be prompted again to enter credentials.
- If you tap on Cancel or clear the credentials fields and tap on OK, the radio will not
attempt to associate with that config until you perform one of the following actions
(while the config is the active config):
- Cause the vehicle-mount to go through a power cycle or suspend/resume.
- Disable and enable the radio, or tap the Reconnect button on the Diags windows.
- Modify the config, and tap on Commit.
Alternatively, you can choose another config as the active config and then switch back to the
config for which EAP authentication was cancelled.
2.9.2.3 ThirdPartyConfig
If you choose to configure ThirdPartyConfig, the SCU will work with the operating sys-
tem’s Windows Zero Config (WZC) to configure radio and security settings for the CF radio
installed in the unit.
Choosing this config means that WZC must be used to define the following radio and secu-
rity options: SSID, Auth Type, EAP Type and Encryption.The SCU settings for ThirdParty-
Config include: Client Name, Power Save, Tx Power, Bit Rate and Radio Mode. These SCU
settings along with SCU global settings and the WZC settings will be applied to the
radio module.
2.9.3 Global Settings Tab
The Global Settings tab allows you to define radio and security settings that apply to all
configs (profiles), along with settings that apply specifically to the SCU.