Powerware FCC 15 - Manual (Page 7)

EATON Powerware ® Modbus ® Card User’s Guide S 164201376 Rev C www.powerware.com 3
Chapter 2 Installing the Modbus Card
The Modbus Card is available:
S as a separate card for use with UPSs that have an X-Slot
S factory-installed in a Powerware Expansion Chassis
Use the following sequence for installing the Modbus Card:
1. For four-wire networks only, change the jumpers on the Modbus
Card (see “Four-Wire Communication” on page 4).
2. If the Modbus Card will be the last device installed in the network
chain or the length of the network cable is excessive, termination
needs to be enabled (see “Termination” on page 10).
3. Install the card with the UPS (see the Powerware Expansion
Chassis User’s Guide or “Installing the Modbus Card into an X-Slot”
on page 6).
4. Wire the card to your network (see Chapter 3, “Wiring the Modbus
Card” on page 7).
5. Configure the card (see Chapter 4, “Modbus Card Configuration”
on page 13).
6. Run the Modbus Profiler tool to integrate the UPS data with the
building management software (see Chapter 5, “Integrating the
UPS” on page 17).
Inspecting the Equipment
If any equipment has been damaged during shipment, keep the shipping
cartons and packing materials for the carrier or place of purchase and file
a claim for shipping damage. If you discover damage after acceptance,
file a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with
the carrier within 15 days of receipt of the equipment; 2) Send a copy of
the damage claim within 15 days to your service representative.