Planet Technology WDAP-2000PE - Manual (Page 22)

are enabled, the device can send out TRAP messages automati-
cally to the TRAP manager if configured.
Assign System Informa-
tion
System Name: A name that you assign to your WDAP-2000PE. It
is an alphanumeric string of up to 30 characters.
System Location: Description of where your WDAP-2000PE is
physically located. It is an alphanumeric string of up to 60 charac-
ters.
System Contact: Contact information for the system administra-
tor responsible for managing your WDAP-2000PE. It is an
alphanumeric string of up to 60 characters.
Assign the SNMP Com-
munity String
Community String For Read: If you intend the access point to
be managed from a remote SNMP management station, you need
to configure a read-only “community string” for readonly operation.
The community string is an alphanumeric string of up to 15
characters.
Community String For Write: For read-write operation, you
need to configure a write “community string”.
Assign a specific name
and IP address …
A trap manager is a remote SNMP management station where
special SNMP trap messages are generated (by the Access
Point) and sent to in the network. You can define trap managers
in the WDAP-2000PE.
You can add a trap manager by entering a name, an IP address,
followed by pressing the ADD button.
You can delete a trap manager by selecting the corresponding
entry and press the DELETE SELECTED button.
You can enable a trap manager by checking the Enable box in
the corresponding entry or disable the trap manager by un-
checking the Enable box.
3.5.4 MAC Filtering Settings
The WDAP-2000PE allows you to define a list of MAC addresses that are allowed or denied to
access the wireless network.
20