Planet Technology WDAP-2000PE - Manual (Page 8)

Installation
Rear View
Connector Description
ANT
Two dipole antennas are supplied. Best result is usually
obtained with the antenna in a vertical position.
Power Connect the supplied power adapter here.
Reset Button
In order to clear ALL settings and restore to factory
default, holding the Reset Button down continuously for 5
seconds.
LAN (PoE)
Use a standard LAN cable (RJ-45 connectors) to connect
this port to a 10BaseT or 100BaseT hub on your LAN.
1.4 Specification
Model WDAP-2000PE
Standard IEEE 802.11b, 802.11g, 802.11a
Signal Type DSSS (Direct Sequence Spread Spectrum)
Modulation
OFDM with BPSK, QPSK, 16QAM, 64QAM, DBPSK, DQPSK,
CCK
Port 10/100Mbps RJ-45 port * 1, 802.3af compliant
Antenna Connector Reverse SMA male x 2
Wireless Transmit
Power IEEE802.11a mode: 17dBm@54Mbps
20dBm@6Mbps
IEEE802.11g mode: 17dBm@54Mbps
20dBm@11Mbps
20dBm@1Mbps
IEEE802.11b mode: 14dBm
Wireless Receive
Sensitivity IEEE802.11a mode: -85dBm@6Mbps
-65dBm@54Mbps
IEEE802.11g mode: -91dBm@1Mbps
-84dBm@11Mbps
-65dBm@54Mbps
Operating Mode AP, WDS mode
Security
WEP, WPA with PSK/TKIP/AES support
802.1x authentication /EAP-TLS/EAP-TTLS/EAP-MD5/EAP-
PEAP
MAC filtering authorized
Block SSID broadcast
5