PSC PT Program Generator - Manual (Page 175)

User’s Guide
163
Appendix D
PPG System Commands
Overview
To use PPG to reset the default settings on the PDT, enter the human readable
portion of these bar codes at the system command prompt. This is useful to
automatically change modes for the user. The following bar codes are provided
in this section:
• Using Predefined Defaults on page 164 .
• Alternate Parameters on page 165 .
Additional setting bar codes are provided in the Programming chapter in the
PSC Falcon PT40 Product Reference Guide . Enter the human readable portion at
the system command prompt in the Output node Properties dialog.
Figure 130. System Command Field in the Output Node
2342.book Page 163 Thursday, July 22, 2004 8:35 AM