Panasonic AJ- DCP - Manual (Page 31)

31
111 AFTER CUE-UP
0000
0001 STOP
STILL
For setting the status after cue-up.
0: For stopping the tape in the stop mode.
1: For stopping the tape in the still mode.
115 EJECT EE SEL
0000
0001 EE
BLACK
For selecting the video output and audio output while the tape was being
ejected when the TAPE/EE switch has been set to TAPE.
0: The E-E picture and E-E sound are output.
1: The E-E picture and E-E sound are muted.
112 CAP LOCK
0000
0001 2F
4F
For setting the capstan lock mode.
0: Capstan locks at 2F.
1: Capstan locks at 4F.
OPERATION menu
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
The underlining indicates the factory setting.
200 ID SEL
0000
0001 OTHER
DVCPRO
For setting the ID information to be returned to the controller.
0: 20 25H is returned.
1: The DVCPRO unit’s own ID (F0 33H) is returned.
INTERFACE menu
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
The underlining indicates the factory setting.
Setup Menus
110 AUTO BACK
0000
0001
0002
OFF
REC-P
ALL
For setting the operating method in the no-gap mode.
(Specifies whether or not to use the AUTO BACK function, which rewinds
the tape for a few seconds to eliminate gaps and distortion between
segments.)
0: No AUTO BACK function.
1: Auto back is performed when switching to the REC PAUSE mode, after
which the unit remains in REC PAUSE status. (When PAUSE is
cancelled, the tape is advanced and then recording starts.)
2: In addition to the functions of setting 0001 “REC-P,” AUTO BACK is
performed when switching to the REC PLAY mode, immediately after
which the tape is advanced and recording starts.
113 BATTERY SEL
0000
0001
0002 NiCd-12
NiCd-13
NiCd-14
For setting the type of battery.
0: 12V battery
1: 13V battery
2: 14V battery
114 FRZ MODE SEL
0000
0001 DIS
STBOFF
For selecting the output picture in the STANDBY OFF (HALF LOADING)
mode when the TAPE/EE switch has been set to TAPE.
0: The output picture is muted.
1: The playback picture is frozen for output as soon as the STANDBY OFF
(HALF LOADING) mode is established.
109 MEMORY STOP
0000
0001 OFF
ON
For setting whether to stop the tape when the CTL counter reading
becomes zero during fast forwarding or rewinding. (This item functions only
in the CTL mode.)
0: The tape is not stopped.
1: The tape is stopped.