Panasonic AJ- DCP - Manual (Page 33)

33
500 VITC BLANK
0000
0001 BLANK
THRU
For setting whether the VITC signal is to be output to the composite video
output.
0: VITC signal is not output.
1: VITC signal is output.
505 TC PRESET For setting the time code value when P-REC or P-FREE has been selected
as the TCG mode setting by the menu item No.504 (TC MODE).
After the + or – button is pressed, select the digit to be changed using the
UP or DOWN button, and then change the value using the + or – button
again.
506 UB PRESET For setting the user’s bit value when P-REC or P-FREE has been selected
as the TCG mode setting by the menu item No.504 (TC MODE). After the +
or – button is pressed, select the digit to be changed using the UP or
DOWN button, and then change the value using the + or – button again.
508 PHASE CORR
0000
0001
OFF
ON
For setting whether to control the phase compensation of the linear time
code which is generated by the TCG.
0: No phase correction control is exercised.
(LTC phase correction bit: 0)
1: Phase correction control is exercised.
(LTC phase correction bit: 1)
507 BINARY GP
0000
0001
0002
0003
0004
0005
0006
0007
000
001
010
011
100
101
110
111
For setting the usage status of the user’s bit which is generated by the
TCG.
0: NOT SPECIFIED (character set is not specified)
1: ISO CHARACTER (8-bit character set complying with the ISO-646 or
ISO-2022 standard)
2: (Undefined)
3: (Undefined)
4: (Undefined)
5: PAGE/LINE
(page/line multiplexing system complying with SMPTE262M standard)
6: (Undefined)
7: (Undefined)
501 VITC POS-1 0000
0006
0010
10L
16L
20L
For setting the position where the VITC signal is to be inserted.
(The same line as the one used for VITC POS-2 cannot be set.)
502 VITC POS-2 0000
0008
0010
10L
18L
20L
For setting the position where the VITC signal is to be inserted.
(The same line as the one used for VITC POS-1 cannot be set.)
503 TCG REGEN
0000
0001
0002 TC&UB
TC
UB
For setting the signal which is to be regenerated when the time code
generator (TCG) is in the regeneration mode.
0: Both the time code and user’s bit are regenerated.
1: Only the time code is regenerated.
2: Only the user’s bit is regenerated.
504 TC MODE
0000
0001
0002
0003
0004
P-REC
P-FREE
I-REG
E-VITC
E-LTC
For setting the TCG mode.
0: The time code is counted up simultaneously with the recording.
1: The time code is counted up irrespective of the VTR mode.
2: The time code is counted up in such a way that it follows on the tape.
3: The mode is synchronized with VITC which is superimposed onto the
video input.
4: The mode is synchronized with LTC in the TC input.
TIME CODE menu
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
The underlining indicates the factory setting.
Setup Menus