Cd/dvd drive, Inserting/removing a disc, Power-saving mode – Panasonic CF-52 Series User Manual
Page 30
30
CD/DVD Drive
1
Turn on the computer.
2
Press the eject button (A) and slowly pull out the tray.
3
Insert/Remove a disc.
z
To insert
Set the disc with the label side up and press the center of the disc until it clicks
in place.
z
To remove
Press on the center spindle (B) and carefully lift up the edge of the disc.
4
Close the tray.
Do not press the eject button.
NOTE
z
To remove a disc when the computer is powered off, insert a pin of 1.3 mm {0.05
″} in
diameter into the emergency hole (C). (When the diameter of the pin is smaller than
this, insert the pin slightly downward.) Pushing it to the end allows the tray to come out.
(The position of the emergency hole depends on the drive.)
z
For AutoPlay CD/DVD:
• If an AutoPlay CD/DVD does not start after the computer resumes from sleep or hiber-
nation, remove the disc from the drive and then reinsert it after waiting 15 seconds.
• An AutoPlay CD/DVD may start during file access depending on the status of the disc.
z
When playing back motion video from a disc, playback may not be smooth in some con-
ditions.
Power-saving mode
If the CD/DVD drive is not accessed for 30 seconds, the drive motor will automatically be shut down to reduce the power con-
sumption. When the CD/DVD drive is accessed again, the drive motor is turned on. In this case, reading of the disc data will
take approximately 30 seconds.
Inserting/Removing a Disc