Pc card / expresscard, Inserting/removing the card – Panasonic CF-52 Series User Manual
Page 33
33
PC Card / ExpressCard
You can insert the following cards.
z
ExpressCard/34 or ExpressCard/54 to the ExpressCard slot (A)
(Only for model with ExpressCard slot)
z
PC Card Type I (3.3 mm) or II (5.0 mm) to the PC Card slot (B)
NOTE
z
The following types of card are not supported:
PC Card Type III (10.5 mm), ZV card, SRAM card, FLASH ROM card (excluding ATA interface type), and other cards
that require 12 V of operating voltage.
z
Do not start up Windows with a storage type of CardBus PC card attached. An error may occur.
z
Dummy cards are inserted into both of the slots at the factory.
First remove the dummy cards (below).
z
Be sure to insert each dummy card when the slots are not in use.
z
Insert the appropriate dummy card in the correct card slot. Insert the dummy PC Card in the PC Card slot, and the
dummy ExpressCard in the ExpressCard slot.
Inserting a dummy card in the wrong slot may cause malfunction of the computer.
Preparation
z
Attach the device for the media containing the card driver (e.g., CD-ROM). Equipment connected to the multimedia
pocket cannot be recognized if connected after the card driver installation screen appears.
z
If the dummy card is inserted, remove it.
To insert the card
1
Open the cover (C), and insert the ExpressCard (D) or the PC
Card (E) with the label side up until it securely fits in to the slot.
z
For further information, refer to the instruction manual of the card.
To remove the card
1
Disable the card function.
A
Click
on the notification area and click
.
B
Select the card.
z
These steps are not necessary when removing the card after turning off the
computer.
Inserting/Removing the Card