Rack-mount setup – Powerware 9125 Two-in-One UPS 2500 User Manual
Page 23
INSTALLATION
EATON Powerware
®
9125 Two-in-One UPS (2500/3000 VA) User’s Guide
S 164201374 Rev D
www.powerware.com
17
Rack-Mount Setup
The UPS can be installed in 19-inch racks and needs only 2U of valuable
rack space.
C A U T I O N
The UPS and EBM are heavy (see page 61). A minimum of two people are required to lift the
cabinets into the rack.
NOTE Mounting rails are required for each UPS and EBM cabinet. If rails are not already
installed in your rack, contact your local distributor to order rail kits.
To install the UPS and optional EBMs in a rack:
1.
Place the UPS on a flat, stable surface with the front of the UPS
facing toward you.
2.
Attach the supplied mounting handles to the mounting brackets and
secure with the supplied screws (see Figure 5).
3.
Align the mounting brackets with the screw holes on the side of the
UPS and secure with the supplied screws (see Figure 5).
4.
If installing optional EBMs, repeat Steps 1 through 3 for each
cabinet.
Mounting
Handle
Mounting
Bracket
Figure 5. Installing the Mounting Handles and Brackets