Powerware 9125 Two-in-One UPS 2500 - Manual (Page 29)

INSTALLATION
EATON Powerware ® 9125 Two-in-One UPS (2500/3000 VA) User’s Guide S 164201374 Rev D
www.powerware.com
23
4. E/EH UPS models have a battery connector cover that must be
removed before installing the EBM(s). Remove the cover from the
rear panel as shown in Figure 15.
NOTE Keep the battery connector cover and screws for future use. If the UPS is stored or
used without an EBM, the battery connector cover must be installed as a safety precaution.
Battery Connector Cover Screws
Figure 15. Battery Connector Cover (E/EH UPS Models Only)
5. Remove the cover from the EBM cable as shown in Figure 16.
NOTE Keep the EBM cable cover and screws for future use. If the EBM is stored or
removed from the UPS, the EBM cable cover must be installed as a safety precaution.
EBM Cable with Cover
Figure 16. EBM Cable Cover (E/EH UPS Models Only)