Printek 4503 - Manual (Page 124)

Printek Emulation
Page 7-12
Horizontal and Vertical Tabs
Reset Horizontal and Vertical Tab Stops ESC R
Clears all currently set horizontal tab stops, and restores the default horizontal tab
stops. Default horizontal tab stops are set at every eighth column, i.e. column 8, 16,
24, 32, 40, etc. Clears all currently set vertical tab stops.
Escape Sequence: ESC R
Hexadecimal: 1B 52
Horizontal Margins
Printing is allowed only within the left and right margins. Exceeding the right margin
will cause line wrap, setting the current print position to the left margin and
advancing the paper one line.
Set Left and Right Margin ESC H n1 n2
Sets the left margin to column n1 and the right margin to column n2 at the current
character spacing. 0
≥
n1
≥
255, 0
≥
n2
≥
255. If character spacing is changed after
setting the margins, the position of the margins will not change.
The left margin is inclusive, but the right margin is exclusive. For example, a left
margin at column 10 still allows a character to be printed in column 10. A right
margin at column 75 allows a character to be printed in column 74, but not in column
75.
The leftmost column is column zero. The left margin must be left of the right margin
and
≤
13.4 inches. The right margin must be right of the left margin and
≤
13.6 inches.
Invalid margins will be ignored. Overrides the "Left Mar:" and "Right Mar:" values
in the "Setup: FORM" menu.
Example: The following escape sequence will set a one inch left margin, and will set
a right margin 7.5 inches from the left edge of the form, if character spacing is
currently 10 cpi. For a standard 8.5 inch wide form, this would result in a one inch
right margin.
Escape Sequence: ESC H 10 75
Hexadecimal: 1B 48 0A 4B