Printek 4503 - Manual (Page 43)

Epson FX Emulation
Page 3-15
Set Line Spacing to n/72" ESC A n
Sets the line spacing to n/72 of an inch per line. 0
≥
n
≥
255. Since the distance
between print head wires is 1/72 of an inch, this is equivalent to setting n wire
spacing. Overrides the "LPI:" value in the "Setup: FORM" menu.
Example: The following escape sequence will set line spacing to 8/72 of an inch, for
use with eight wire graphics.
Escape Sequence: ESC A 8
Hexadecimal: 1B 41 08
Horizontal Position
Carriage Return CR
Causes the current line to be printed, and then sets the current print position to the left
margin. If "Auto LF: On" is selected in the "Setup: INTERFACE" menu, a line feed
will also be performed.
Control code: CR
Hexadecimal: 0D
Backspace BS
Causes the current line to be printed, and then moves the current print position one
space to the left. The actual distance moved depends on the current character
spacing. Backspacing can be done up to, but not beyond, the left margin.
Control code: BS
Hexadecimal: 08