Printek 4503 - Manual (Page 7)

Table of Contents
v
CHAPTER 7 - PRINTEK EMULATION 7- 1
Introduction 7- 1
Control Codes and Escape Sequences 7- 3
Communications 7- 3
Character Size 7- 4
Character Attributes 7- 5
Character Sets 7- 6
Line Pitch 7- 7
Horizontal Position 7- 8
Vertical Position 7- 8
Form Length and Form Feed 7- 9
Horizontal Tabs 7-10
Vertical Tabs 7-11
Horizontal and Vertical Tabs 7-12
Horizontal Margins 7-12
Vertical Margins 7-13
Graphics 7-14
Printer Controls 7-17
Forms and Tractors 7-19
Emulations 7-20
Control Codes and Escape Sequences (Alphabetical) 7-21
CHAPTER 8 - HEX DUMP MODE 8- 1
APPENDIX A - OPTIONAL COAXIAL/TWINAXIAL INTERFACE 1
Introduction A- 1
Automatic Port Switching A- 1
Command Interpreter A- 2
APPENDIX B – Printing Basic BAR CODEs B- 1
Introduction B- 1
Bar Code Sequences B- 4
Measurements in Bar Code Mode B- 4
Entering/Exiting Bar Code Mode B- 5
The Bar Code Control Character B- 5
Other Control Characters B- 5
Bar Code Definition B- 6
Bar Code Height B- 9
Relative Vertical Tab B-10
Absolute Horizontal Tab B-10
Bar Code Pass Terminator B-11
Mixing Bar Codes and Text B-12
Supported Bar Code Types B-13
APPENDIX C - ASCII CHARACTER TABLES C- 1
ASCII Control Code Definitions C- 1
Decimal to Octal to Hexadecimal Conversion Table C- 7
APPENDIX D - PRINTER RESET CONDITIONS D- 1
GLOSSARY Glossary- 1