Primera Technology RX900 - Manual (Page 10)

6 Label Stock
Section 2: Label Stock
A. LABEL AND ROLL SPECIFICATIONS
A wide variety of label stock can be used in the Printer. Refer
to the specifications and settings in the following sections
before ordering custom stock from Primera or any stock from
another company.
Important! Test all custom made label stock with the intended printer before
ordering large quantities! Primera will only assume responsibility for custom
label stock ordered from Primera.
Label Width
Liner Width
Width of Opening
Black Mark
Width
Gap Between
Labels
Label Height
Distance from
edge of Media
Label Sensing Methods
Method 1: Label
Gap Sensing
Method 2: Thru-Hole
Sensing
Method 3: Reflective/Black
Mark Sensing
(Black Mark must be printed
on back side of label stock)
Note: See table below for Max and Min
values in inches and mm..
Feed Direction
RFID: Antenna should
be 0.25" (6.35mm)
+/- 0.08" (2mm) from
leading edge of label.
RX900.qxd 2/17/2011 1:26 PM Page 6
TOC INDEX